I updated last week my remote and aircraft from 4.0 firmware to 6version, I knew I had to comply with remote id so I did  all the steps to make sure the info was right, but when I try to fly it just Says REMOTE ID BROADCAST ERROR , and don’t let me fly. I’ve tried to check the wireless signal broadcasting from the remote/drone but nothing comes up. Does anyone has experienced that ?

My M300/P1 and controller are up to date as of yesterday and i have not had any issues either connected or disconnected to the internet. This includes flying in a zone that requires geo-unlocking.

I'll update this with the version number next time I put it all together.