Hi all!I updated my Ph2 with the app for Mac and after that, I have a pop-up message error (Error 33) and the LEDs are flashing red very fast! I updated a second time and nothing as changed...the Ph2 flies well anyway!

Thanks

Try to calibrate the remote control by using DJI RC System Assistant!

jackson.zhong@d Posted at 2014-12-8 14:29
Try to calibrate the remote control by using DJI RC System Assistant!

Nothing has changed

vincenzo.divinc Posted at 2014-12-9 00:01
Nothing has changed

Show me your picture.

I had the same problem.  I upgraded the remote control  (firmware 1.0.1.24)  and the lights is flashing OK.  I didn't  flight test  yet!

0724 Posted at 2014-12-10 23:07
I had the same problem.  I upgraded the remote control  (firmware 1.0.1.24)  and the lights is flash ...

This is the screenshot. I upgraded the RC, but nothing has changed.....

I was wrong, i upgraded the RC and nothing has changed too. I have 2 batteries and i realized that this issue happens in one of them, with the other phantom works almost normally....
During the upgrade i've had error twice with this "bad" battery, i tried another time and finished ok.

With my other "good" battery... after upgrade phantom and battery, the  GPS/Att Mode don't work normally. For example, i set  GPS mode (S1 position 1)  but phantom lights sometimes flashing yellow (att mode), sometimes Green (GPS mode),  the screen shows the Mode blinking between GPS and ATT. ...well i don't know what to do!!