Hi all, been flying my Mini 3 pro for a while now a recently noticed that if the gimbal goes off level due to a sharp roll or turn all though it gets most of the way to level. to get to actual level (sea horizon level with grid lines, can take 30 or more seconds in the worst case scenario.

Is there a way to speed this up.

Hi there, could you please provide us with a screen recording showing the issue for our better confirmation? You can upload the video to Dropbox or Google Drive and then send us the link here.

i have up loaded a video on Youtube which clearly shows the horizon not being level

stevesbgmx.com Posted at 5-28 00:27
i have up loaded a video on Youtube which clearly shows the horizon not being level

https://youtu.be/Ahjgrw5M_6c

Please check the wind velocity in the flight environment, the stabilization effect will be affected by strong wind. We recommend changing to another environment for a test. If the control stick is pushed with too much force, the aircraft speed will be high, which reduces the stabilization effect. It is recommended to push the control stick gently. Please also ensure that the aircraft is not in S mode when flying.

As you can see in the video the wind is not strong (the waves are little) the drone was in normal mode. and also you can see drone is flying slowly forward and backwards.
airdata link

https://app.airdata.com/share/hDNbIE

the above video is from aprox 14 min in the log.

proof there is no wind, watch to the end.

stevesbgmx.com Posted at 5-28 05:52
https://youtu.be/ybedRQv8fZk
proof there is no wind, watch to the end.

Hello, there. Sorry for the inconvenience. If so, you may try whether the below troubleshooting steps work for you.
1. Remove the microSD card from the aircraft. Place the aircraft in a stable status and restart it.

2. Please try with gimbal calibration, resetting gimbal parameters, and IMU calibration.

3. Connect the corresponding DJI Assistant 2 for firmware updating

DJI Wanda Posted at 5-29 00:27
Hello, there. Sorry for the inconvenience. If so, you may try whether the below troubleshooting steps work for you.
1. Remove the microSD card from the aircraft. Place the aircraft in a stable status and restart it.

Hello i have tried all of the above.
nothing has worked.
i did another test flight this morning and the symptoms are the same.
Thank you

stevesbgmx.com Posted at 5-29 01:46
Hello i have tried all of the above.
nothing has worked.
i did another test flight this morning and the symptoms are the same.

Thanks. If so, you are advised to send it back for further diagnosis. Here is the link:
https://repair.dji.com/us/repair/index