I got a message: turn off the drone and calibrate the rc, when rc connects to the drone after startup, but when I choose to calibrate I get a page where it says how to turn and flip the rc (with drawings), as well as a text box with the message 'start calibration'
If I press 'start calibration' it takes 1/10 of a second and the message calibration complete comes up.

It was not like this the last time I had to calibrate, then I had to turn the rc in different directions before I was told that calibration was done.

Everything works as it should after calibration, with only the usual start-up messages.

Is this a normal behavior?

Hi there. Thank you for bringing this inquiry to us. Please provide us a screen recording showing the process when you perform the calibration so we can verify it and provide you with an accurate resolution. Please keep us posted. Thank you.

Try again, get to the RC Calibrate screen, this time hold a magnate at the back of the RC near the middle towards the lower edge, this will force it into knowing that there is something wrong, now put the magnate at least 5m away so its not going to interfere, now perform the calibration but be quick, you only get a couple of quick movements in before it says its done, you will prob need to do it a few times when you relaise how quick it is, you must make the movements its asking too, again, do it fast, quick rocking left to right x2 and same front to back, youll get the hang of it

DJI Paladin Posted at 6-23 21:47
Hi there. Thank you for bringing this inquiry to us. Please provide us a screen recording showing the process when you perform the calibration so we can verify it and provide you with an accurate resolution. Please keep us posted. Thank you.

This worked perfectly

Aurgelme Posted at 6-25 00:56
This worked perfectly

If you still experience the issue, Aurgelme, please try the suggestion of Bashy on post #3. Thank you.