Hello,

I recently damaged my mini 3 pro gimbal and ordered a replacement gimbal. I was able to install the replacement gimbal and am currently getting the followind codes

Camera not calibrated 10016
Gimbal IMU data error 40021

The aircraft flies but the gimbal sits at a skew and I get a gimbal motor overload warning after a little bit.

My searches have indicated replacing gimbals requires a roll back or parameters change. Is this correct? Can you help? Thanks.

Have you recalibrate the camera and the gimbal, since replacing the gimbal?

Hi there. Thank you for reaching out and we're sorry for this unpleasant experience. You may consider sending the unit in for a proper diagnosis. You may submit a ticket case at https://repair.dji.com/repair/index . Thank you for your understanding and support.

sadly you need access to the DJI diagnostic software to pair the gimbal and drone together,     best just to let them repair it they are very reasonable cost wise and usually they send you a new drone.  

incompatible gimbal data mini mavic

md Oalid Posted at 8-28 11:09
incompatible gimbal data mini mavic

Hi there,
thank you for reaching out.

Please provide a screenshot of the error message in question. Additionally, you might attempt the following troubleshooting steps to determine if the issue can be isolated.

1. Please go to Settings-Control-Gimbal Calibration.

2. Please go to Settings-Safety-IMU Calibration.

Note: If an SD card is installed, try removing it before calibrating.

Please keep us posted. Thank you.

i have these errors :
does anyone can help me find out the answer?

tramrey02 Posted at 10-16 05:29
i have these errors :
does anyone can help me find out the answer?
[view_image]

Hi there,
thank you for reaching out.

We apologize for the inconvenience. Could you please confirm whether you have performed an IMU calibration and updated the firmware? If so, it is best to send the unit in for a thorough diagnosis. An online repair request can be submitted at the following link: {https://repair.dji.com/repair/index}. Should you require help with ticket creation, DJI support is available at https://www.dji.com/support.

Your kind understanding is appreciated and thank you for your continued support.

I keep getting this msg and when I try to start imu calibration it won't start and also compass calibration doesn't work but says normal

Vincent Cloete Posted at 10-30 15:19
I keep getting this msg and when I try to start imu calibration it won't start and also compass calibration doesn't work but says normal

Hi there,
thank you for reaching out.

We apologize for the inconvenience. Please try to restart the gimbal and calibrate the IMU. If the issue persists, we recommend you send the drone back for inspection.