hi guys  just bought the fc40 wicked machine but when i connect the usb to my lap top it does not connect to rc assistant or nazam assistant i can hear the pc when connects but no joy connect to any of the software thave tried too,

                                                           any idea dudes thx paul

You need to download the driver at Dji

jamesnns@gmail. Posted at 2014-12-8 22:04
You need to download the driver at Dji

Cheers I'm not sure if ive done that but I'll check it but Thx for the reply james

jamesnns@gmail. Posted at 2014-12-8 22:04
You need to download the driver at Dji

Cheers I'm not sure if ive done that but I'll check it but Thx for the reply james

hiya again yes i downloaded the driver   BINGO i think i must of  downloaded the  RC software instead but you guys are wicked

:):):):):):)

Make sure you do an advanced IMU calibration after updating to Firmware Ver. 4.02.
If you get a warning stating it 'too hot' to continue, ignore it and continue.
Also make sure your IOC is enabled and your S1 switch, in its lowest position, is set to Fail Safe mode and not Atti mode in your Naza Asst.

I made that mistake, almost lost my bird.

connected(best I understood how), shows and states no update needed, where is the 4.02?