Hello all,
We have just updated to firmware v7.0xx. When the drone RTH's for a battery swap mid-mission (3 of 5 legs complete) I am no longer receiving an automatic resume on relaunch, that worked well previously. The new UI isnt as intuitive as the older v4 it seems. At one point I did get it to popup the little dialog with the 5 legs, I told it to start as I was assuming it would resume the mission, it didn't. I guess I should have told it leg 4. Maybe I'm a newb. I dont get to use this as often as I like.

No KMZ/KML was used.No use of Mapbox.

Should I have manually paused the Task first?
What is the best way with the new UI to resume a multi-leg Oblique mission?

Is anyone else running into this?

I appreciate any assistance!

Hello all,
We have just updated to firmware v7.0xx. When the drone RTH's for a battery swap mid-mission (3 of 5 legs complete) I am no longer receiving an automatic resume on relaunch, that worked well previously. The new UI isnt as intuitive as the older v4 it seems. At one point I did get it to popup the little dialog with the 5 legs, I told it to start as I was assuming it would resume the mission, it didn't. I guess I should have told it leg 4. Maybe I'm a newb. I dont get to use this as often as I like.

No KMZ/KML was used.No use of Mapbox.

Should I have manually paused the Task first?
What is the best way with the new UI to resume a multi-leg Oblique mission?

Is anyone else running into this?

I appreciate any assistance!