Had my old inspire 1 out and found the landing legs aren’t going up.  They are stuck in landing position. Tried to see if there was something stuck, but don’t see anything out of place.  Also tried to move it without the props on and it SOUNDS like the motor to move the landing legs is working, but nothing happens.  

Are there any resources or tricks to get the legs to move?  Or should I just send it in to DJI?  Or any local places (preferable) NYC area?

Luckily the case I have allows it to stay in landing configuration, so I still can fly it.  And it flies great!

It has been sitting for years unfortunately.  But would like to get it in full working order.  

Thanks for any suggestions

Hi, KC-FPV. Please refer to our reply on this thread. Thank you.