I just updated the Dji fly application to 1.11.4, updated the firmware to 02.04.2500, and updated the RC-N1 via DJI Assistance. But after all the Remote won't connect to the drone (Dji Air 2S). Can anyone help?

Now only DJI can help you. Bad idea to update N1 if Dji fly application no prompt you for this.

LoveYou Posted at 9-7 00:41
Now only DJI can help you. Bad idea to update N1 if Dji fly application no prompt you for this.

Thank you for the information. Hopefully Dji can provide an explanation about this.

Connect to your PC using the DJI Assistant 2 for Consumer Series Drones app and upgrade/refresh the firmware. On both the controller (bottom USB port), and the drone (side USB port).

Yaros1 Posted at 9-7 08:49
Connect to your PC using the DJI Assistant 2 for Consumer Series Drones app and upgrade/refresh the firmware. On both the controller (bottom USB port), and the drone (side USB port).

I already did that. I refreshed firmware by Dji Assistant to 02.04.2500 and RC-N1 on my PC, and even after I did all that, the drone didn't connect to the Remote.

Finally I returned DJI Fly to the old version 1.10.6 and now everything is working normally again. The conclusion is that we don't always have to update the latest version.

Hi. I'm glad the problem was already sorted out. Please reach back if you have further concerns. Have a great day ahead.

DJI Tony Posted at 9-7 23:54
Hi. I'm glad the problem was already sorted out. Please reach back if you have further concerns. Have a great day ahead.

Thank you very much

djiuser_lqlT8OCbjMVH Posted at 9-8 00:39
Thank you very much

You are most welcome. Thank you for your valued support.