We purchased the DJI Pro SSD to use with the Ronin 4D because we were led to believe it would provide us with the most flexibility in recording format and framerate control. However, with the DJI Pro SSD (or any other medium of storage for that matter), we are unable to set the camera's sensor FPS to anything higher than 60fps with *any* combination of resolution, codec, aspect ratio, or sensor capture area (We tried them all and even referenced the data sheets) -- so where is 120fps? Where is 72, 96? We have all the requirements, and latest firmware.

We also can not set the frame rate any lower than 23.976 -- Which, is not ideal for a cinema camera -- Frame rates like 22, 20, and even 18 have a purpose that, while under-used, is a "not possible" situation with this camera in the current state of it.

Nevermind, we finally found it in a sub-menu within the FPS menu.
However, the sub-menu is not accessible from the on-board monitor. We can only get the "slow" button to show up on the high-bright remote monitor.
...and then, when we rebooted the camera after finding it this one time, it is no longer there as an option in the FPS menu.

So.... still nothing beyond 60fps is selectable no matter what configuration we try, despite now knowing that it "should" be there, but isn't.

Would still be a massive benefit to be able to record at lower frame rates than 23.976