Ok using assistant 2 consumer, windows 10.  Can see drone,  it collects update from net then dies trying to apply it to drone.

Issues with this since i got it.

Have error error 5-100-4.

It's as if the software cannot write to the drone.  Just picked up Avata, updated no problem, also, updated googles,two controllers, again, no problem.

Does the fpv need sd card formated in a certain way or acces?

Hi there. We do apologize for the trouble. Kindly please enter the "Device Manager" on your PC and find "Network adapters">"remote NDIS based Internet Sharing Device" If this setting was disabled, please enable it and check if the issue persists. Please keep us posted. Thank you.

K it is enabled, there is an issue under events.

keep getting stuck at the writing to drone.  Downloads fine.

Ok, so, anyone have an idea?  Why can I update my avata, but not the fpv drone?

Should be the same, right?

djiuser_O3LNMlqGpwyn Posted at 10-5 12:53
Ok, so, anyone have an idea?  Why can I update my avata, but not the fpv drone?

Should be the same, right?

Hi there. Sorry for the late response. I'm afraid that you may consider sending the unit in for a proper diagnosis. You may contact our support team to start up a ticket at https://www.dji.com/support . Thank you for your understanding and support.

Ok, had reinstalled third time. The slabvcp.inf failed to install.  Could this be the problem?  What does it do?