Hello,

My Mavic 2 Zoom is not connecting to the primary controller. I tried updating the software as well. When I try to bind Mavics yellow lights keep blinking but nothing happens.

Please suggest me what to do

Hi there, thank you for reaching out. Kindly follow the steps below.

The remote controller is linked to your aircraft before delivery. Linking is only required when using a new remote controller for the first time. Follow these steps to link a new remote controller:

1. Power on the aircraft and the remote controller.

2. Launch DJI GO 4.

3. Enter “Camera” and tap on the controller/signal icon and then tap the button to confirm. The remote controller is ready to link.

4. Locate the link button on the side of the aircraft, as shown in the figure below. Press the link button to start linking. The Linking Status Indicator displays solid green once the remote controller successfully links to the aircraft, and the LCD screen on the remote controller displays the aircraft’s information.

Ensure the remote controller is within 1.6 ft (0.5 m) of the aircraft during linking.

The remote controller will unlink itself from an aircraft if a new remote controller links to the same aircraft.

In Dual Remote Controller Mode, the Secondary remote controller must also be relinked to the aircraft when the Primary remote controller is relinked to the aircraft.

If you have any further questions or concerns, please do not hesitate to contact our support team. We are always happy to help you!