Ive searched and found a few have had similar issues, but most very old like a year ago. One was recent but un-resolved.

New Phantom 3 Pro as of about 3 weeks ago. Began FW upgrade process yesterday 9/5, it wasnt exactly smooth, had to re-instal FW on the aircraft but eventualy everything "seemed" to be working properly (not sure about gimble yet, but at least the FW took and was communicating with RC). Then did an IMU cal, after which I re-booted eveything and realized then that the gimble was limp. It moved a bit on start up, but then camera points down and is unresposcive to RC.

Any idea's?

Ive searched and found a few have had similar issues, but most very old like a year ago. One was recent but un-resolved.

New Phantom 3 Pro as of about 3 weeks ago. Began FW upgrade process yesterday 9/5, it wasnt exactly smooth, had to re-instal FW on the aircraft but eventualy everything "seemed" to be working properly (not sure about gimble yet, but at least the FW took and was communicating with RC). Then did an IMU cal, after which I re-booted eveything and realized then that the gimble was limp. It moved a bit on start up, but then camera points down and is unresposcive to RC.

Any idea's?