Philamedia
 lvl.2
United States
Offline
|
I'm having trouble getting the Three-Channel Follow Focus to work. I have the most recent firmware on the High-Bright monitor, and all other accessories.
My setup is as follows:
Sony Fx6 with DJI Lidar / Cable Hub
DJI Focus Motor (2022)
DJI Transmitter
DJI High-Bright Monitor (in Control mode) with Three-Channel FF
Everything is powered on, the image is transmitting fine, the high-bright monitor recognizes the Three-Channel FF (green light on the FF, and the instructional pop-up shows on screen when connected), and the focus motor is calibrated on the lens. If I toggle on autofocus (I can do it via the monitor or via the rear button of the FF) the autofocus works fine. But when I switch to manual and I spin the focus dial on the FF, nothing happens. Nothing happens with the iris slider or the zoom rocker either.
I've tried this on two different high-bright monitors, with the same results. However, when using the Ronin 4D handles with the monitors, I have no problems controlling the focus motor.
Any thoughts?
|
|