jtriley
lvl.1
United States
Offline
|
The DJI Goggles V2, O3 Air Unit, and FPV Controller 2 are all linked, the controller can be calibrated in the goggles but in Betaflight the controller inputs are not showing in the Receiver tab.
Hardware:
- Speedybee F7V3 FC
- Speedybee BLS 50A ESC
- DJI O3 Air Unit.
Steps taken:
- updated all firmware to latest version
- selected: COM4 - Betaflight STM32F7x2, 115200
- connected
- set Serial RX for UART1 to on
- set Receiver Mode to Serial (via UART)
- set Serial Receiver Provider to SBUS
- set ESC/Motor Protocol to DSHOT600
- set sbus_baud_fast to ON in Betaflight CLI
- set mode in goggles to SBUS Baud Fast
- saved all settings |
|