hi folks any help with this appreciated
cant get spinners on t40  going and comes up with low voltage and esc issues, any help appreciated

Hi there, we will need to confirm this with the corresponding team, we will keep you updated.

Any advice on this issue as I have the same

djiuser_od0kEHfWEqvD Posted at 3-6 08:56
Any advice on this issue as I have the same

Hi there, may I confirm if your product is also Agras t40 and has the same error messages?

Hi there, please try the suggestions  below to see if it works:
1. Restart the aircraft and see if the error recurs. If it does not appear again, you can use it normally
2. Check the centrifugal motor to see if it is stuck (foreign matter is stuck, the spinner plate is worn, etc.). If so, please clean or replace it in time;
3. Replace the centrifugal motor;
4. Replace the ESC cable.