djiuser_ZgZJGrcJlTPw
lvl.1
Italy
Offline
|
Hi, after an accidental fall I encounter these problems:
1. the latest firmware does not install and gives me an error, both via the controller and with the DJI Assistant 2 app
2. the controller reads as if two are registered, one the Mavic 3T and one the Matrice 3D series when instead I only have the Mavic 3T
3. when I calibrate the IMU it gives me the configuration as if it were the matrix model and not a Mavic
4. it doesn't show me the model on the main screen, even if it is connected
5. it doesn't give me a view of the camera, and the symbol on the SD card shows N/A.
6. the gyroscope sensor works, as do the sensors and the gimbal.
screenshots of the errors below
Thanks for your help
|
|