stworkshop
lvl.1
Singapore
Offline
|
Can someone please help ?
After i upgrade from original firmware to latest Ronin-M Assistant Software v1.9 & GCU firmware v1.1...
my ronin-m becomes unresponsive even though the power is on.
When i open the Ronin-M Assistant Software and go to the "upgrade page", my GCU firmware goes back to v5.1 and tells me to upgrade to latest version 1.1. And when i try to upgrade again following all the instructions, power cycle the device... i come back to the same status v5.1.... i have done this many... many times.
And i always see 2 error message at the bottom of the upgrade page for a few seconds...
1. "Not DJI intelligent battery" in green
2. "IMU must be upgraded" in red
I was suppose to use it for a job tomorrow !!! I should not have upgraded. How can i go back to original firmware ?
|
|