DJI Tony
 Administrator
Offline
|
Hi there. Sorry about the trouble. Can you please try the procedures below and see if it will help:
1. Put the transmitter and receiver into the charging case, close the case, and open it again. Then take out the transmitter and receiver to check whether the pairing is successful.
2. Tap “Link Device” on the touchscreen of the receiver, and press and hold the pairing button on the side of the transmitter. When the indicator on the transmitter is solid green, pairing is successful.
3. If the linking fails after the above steps have been tried, please put the firmware package into the receiver or transmitter that fails to be linked and then refresh the firmware. After the firmware has successfully refreshed, repeat the above operation.
* This is to avoid impact from firmware version differences. If the firmware has already been updated to the latest version, any re-updating will only lead to the prompt “Update failed.”
4. Please verify whether the transmitter is in Bluetooth mode by checking if the system status indicator is solid blue. If the transmitter is in Bluetooth mode, you can press and hold the record button to make the transmitter exit Bluetooth mode. Then put the transmitter to the charging case or relink by tapping Link Device on the receiver.
Please keep us posted. Have a great day. |
|