I have added the motion controller 2 to my avata and it keeps giving me interference problems message. I did a calibration of all I can calibrate in the many, both avata and drone. And it still comes with these messages. What can else be the problem. Anybody who has had same problem ?

Hi there, Is the error "Interference with Motion Controller location"? If so, it is recommended to calibrate the motion controller in an area free of interference. If the issue persists, please try connecting the Motion Controller to DJI Assistant 2 to refresh the firmware. Have a great day.

DJI Tony Posted at 1-29 01:51
Hi there, Is the error "Interference with Motion Controller location"? If so, it is recommended to calibrate the motion controller in an area free of interference. If the issue persists, please try connecting the Motion Controller to DJI Assistant 2 to refresh the firmware. Have a great day.

that is the message yes. I'll try and connect it right away then .

Marclykke76 Posted at 1-29 02:04
that is the message yes. I'll try and connect it right away then .

Alright Marclykke76. Please keep us posted. Have a great day ahead.

DJI Tony Posted at 1-29 02:06
Alright Marclykke76. Please keep us posted. Have a great day ahead.

It says it already has the V01.07.0000 installed. I have tried and do a refresh now.

Marclykke76 Posted at 1-29 02:07
It says it already has the V01.07.0000 installed. I have tried and do a refresh now.

Hi. If it still fails. Please try to calibrate the motion controller in an area free of interference.

DJI Tony Posted at 1-29 02:09
Hi. If it still fails. Please try to calibrate the motion controller in an area free of interference.

As said, i already did that. After it came with the message the last time. But I will try to do again then.