Hello,
I have a problem with inconsistency of FlySafeDatabase between Remote Controler and Aircraft. I have tried so many attempts but results are still only everything is updated or window with uploading to aircraft with 0 percent for many hours and finished with timeout error.
Is there any "hack" how to solve this problem even by uploading "offiline" file than  having this error/warning messages?

PS: Screenshot are attached

Thanks in advance for any reply

Petr Luciak

Have you tried deleting the cache and starting again? That's saved me in the past with corrupted downloaded updates.

Hoarfrost Posted at 2-5 14:49
Have you tried deleting the cache and starting again? That's saved me in the past with corrupted downloaded updates.

Can you help me how to delete the cache ?

Matrice_30_T Posted at 2-5 22:57
Can you help me how to delete the cache ?

Sure. Go to the Shield in the upper left of the main screen and you should find it there.
https://www.flickr.com/photos/10 ... /dateposted-public/

Hoarfrost Posted at 2-6 02:14
Sure. Go to the Shield in the upper left of the main screen and you should find it there.
https://www.flickr.com/photos/102216156@N08/53512720430/in/dateposted-public/

I erased all caches and still the same problem. Remote controller is showing that Flysafe Database is on"Latest version" but on the top is still warning about inconsistency between aircraft and remote controller.

Matrice_30_T Posted at 2-6 02:28
I erased all caches and still the same problem. Remote controller is showing that Flysafe Database is on"Latest version" but on the top is still warning about inconsistency between aircraft and remote controller.

Did you erase the cache while the drone was connected also?

Hoarfrost Posted at 2-6 21:10
Did you erase the cache while the drone was connected also?

Yes i cleaned everything with connected drone. I cleaned also all logs in drone but still the same problem

Matrice_30_T Posted at 2-6 23:19
Yes i cleaned everything with connected drone. I cleaned also all logs in drone but still the same problem [view_image]

I had same issue. I removed the cache without UAV connected, rebooted RC. Then started UAV and message was gone.
Are you on latest FMW?

AR_AirPrecision Posted at 2-7 04:17
I had same issue. I removed the cache without UAV connected, rebooted RC. Then started UAV and message was gone.
Are you on latest FMW?

Hi this didn't help me ... But the new SW/FW release for Controler and Dron updateted (after upgrade) update also FlySyfe DB and everything is without error messages.

Thanks
PL