My P3 Adv arrived yesterday So first thing was to carge battery and RC then to update firmware. everything all good. Apart from the video, any ideas whay its so jumpy,
its only a short video just to show how jumpy it is.
Shot in 2.7k.
NTSC
Heres another if you play in had you will see what i mean
Make sure you have removed the soft foam rubber brace that holds the gimbal in place. I had the same problem. I removed the foam rubber and it is smooth now.
cheers guys il change the settings have a look tomorrow, . yep the foam was removed also i have landing pad but the wind turned gusty quite quick so instead messing about
trying to land on the board i just landed.
thanks again
I didn't see the traditional choppy on my end of the video. I did see that you recorded in 2k though. Could it be that when you viewed the file on your PC, it couldn't handle the higher resolution? I know I just shot video in 2.7k and my laptop was choppy as heck. I was going to upload it to youtube and play it back at a lower resolution to see if that fixed anything on my end. Just a thought.