I have bought a Betafpv Pavo pico with elrs and the Dji 03 air unit. I have managed to bind it to my CR2 and the goggles V2. Everything has the latest software on it.
I see the video feed, the OSD is working. The RC2 beeps as it should when i power up the drone and the green light on the air unit is on.

But in betaflight i dont get any response from the sticks.

Iv'e tried all the recommended Uarts settings shown in all the youtube videos and forum posts i could find but still no input from the sticks i betaflight.
Uart3 disabled
Uart4 VTX (MSP + Displayport) and it's working.

i tried serial RX on UART1,5,6 one at a time and still no response.

The baud rate is set to high och both drone and goggles.

anyone had a similar issue?

Help!

I have bought a Betafpv Pavo pico with elrs and the Dji 03 air unit. I have managed to bind it to my CR2 and the goggles V2. Everything has the latest software on it.
I see the video feed, the OSD is working. The RC2 beeps as it should when i power up the drone and the green light on the air unit is on.

But in betaflight i dont get any response from the sticks.

Iv'e tried all the recommended Uarts settings shown in all the youtube videos and forum posts i could find but still no input from the sticks i betaflight.
Uart3 disabled
Uart4 VTX (MSP + Displayport) and it's working.

i tried serial RX on UART1,5,6 one at a time and still no response.

The baud rate is set to high och both drone and goggles.

anyone had a similar issue?

Help!