Hello after tha aicraft update i lost the sensors.   code: 180059 Aircraft not in flight. Vision systems and obstacle avoidance disabled . and the problem is and when is at tdoes not eneble the sensor. and the gps error is alltime red after update to 7-9 satelite GPS Signal 30008

Do the errors remain after you are flying?

What aircraft update was it?

Hi, Dimis Kat filmnavigate. Thank you for reaching out. May we ask about the firmware version you just updated? Also, was the aircraft on the ground when you received the error? Was there any error while in flight as well?

JeremyB31 Posted at 2-25 13:32
Do the errors remain after you are flying?

yes it is remain

DJI Gamora Posted at 2-25 19:56
Hi, Dimis Kat filmnavigate. Thank you for reaching out. May we ask about the firmware version you just updated? Also, was the aircraft on the ground when you received the error? Was there any error while in flight as well?

Thanks fo your reply the last firmware was at 75% i did complete. and the same. after reset all the problem fixed.

Dimis Kat filmnavigate Posted at 2-25 22:16
Thanks fo your reply the last firmware was at 75% i did complete. and the same. after reset all the problem fixed.

Thank you for the reply, Dimis Kat filmnavigate. Just to confirm, the issue has been resolved after you completed the update?

DJI Gamora Posted at 2-27 05:04
Thank you for the reply, Dimis Kat filmnavigate. Just to confirm, the issue has been resolved after you completed the update?

confirm that

Dimis Kat filmnavigate Posted at 2-27 06:00
confirm that

Thank you for confirming, Dimis Kat filmnavigate. Glad that the issue has been fixed after completing the update. Should you need further assistance, please don't hesitate to reach us again. Have a safe flight always!