Having an issue with balancing the roll axis.
All other axes are balanced perfectly. I then balance the roll axis so it's level, however when I lean the camera to either side, it drifts back to center (with gimbal off).

Hi there, in order to better assist, would you please provide us with a video about your operation? We will see how to figure it out. Thanks.

*You could upload the video to the sharedrive and send us the link.

DJI Thor Posted at 3-14 01:39
Hi there, in order to better assist, would you please provide us with a video about your operation? We will see how to figure it out. Thanks.

*You could upload the video to the sharedrive and send us the link.

Hello, There is a link to the video :

https://www.sharedrive.co/drive/s/7Dq23Xz6hxTrKNeYRVtzleMUuZSyql

When i started filming the tilt and the roll axis already stabilized. The roll axis even when stabilized return to center. NO IDEA WHY

warriors08 Posted at 3-14 03:01
Hello, There is a link to the video :

https://www.sharedrive.co/drive/s/7Dq23Xz6hxTrKNeYRVtzleMUuZSyql

Thank you for the video. We will further check with our engineer team first and keep you updates soon.

DJI Thor Posted at 3-14 03:55
Thank you for the video. We will further check with our engineer team first and keep you updates soon.

Still waiting ...

warriors08 Posted at 3-15 09:27
Still waiting ...

Hi there, sorry for the late response. After checking, based on the video, the right side is slightly heavier than the left. The camera can be tilted on its right side up to an angle of 45°, but when you let go of the left side, it tilts towards the right, indicating that the right side is heavier. However, you can adjust the roll axis to keep it in a neutral position after letting go.  It is suggested that you could fine-tune it with some minor adjustments to see if it works. Thanks.