Use caution with Flytrex on the Inspire had a problem with compass error while flying, if back of Inspire back was facing me everything was ok move facing left or right would get compass error did not make sense, tried flying different location same thing. Removed Flytrex now no more compass error.

ugh.... was just about to install.

I had the same problem after installing the Flytrex Plus on my Inspire.

I found the solution was to make sure that the wide cable that comes from the FC to the adaptor board (and loops right round the compass) was tucked right back close to the FC. What I also did was used the 4 core cable that goes from the adaptor board to the actual Flytrex unit to loop across the front of the wide cable to hold it back against the FC.

I can post a pic of what I did with the cables if that helps.

I then recalibrated the compass to remove any errors and did a test flight using different orientations of the Inspire, and even did 3 POI loops with not a single compass error. :-)

nbarker99999@ho Posted at 2015-9-13 09:10
I had the same problem after installing the Flytrex Plus on my Inspire.

I found the solution was to ...

Yes please post pic's

nbarker99999@ho Posted at 2015-9-14 00:10
I had the same problem after installing the Flytrex Plus on my Inspire.

I found the solution was to ...

I`m using flytrex, yes please post pics. Much appreciated!

I have the same issue. I think that shelding the compass compartment with an antistatic material would solve the problem.

I emailed Flytrex with this problem and sadly no reply.

I have found out that the compass readings are dependable from the position of the cables. I have a video that explains the issue. I am going to  post it tomorrow.

lkedziora@gmail Posted at 2015-10-6 16:31
I have found out that the compass readings are dependable from the position of the cables. I have a  ...

Looking forward to the video.

Here it is:https://www.dropbox.com/s/2dhzatxfq1g4hav/VIDEO0119.mp4?dl=0