Hi,
I've got a strange problem with my newly arrived SDI Transmission System.
I'm sending out 1920x1080p 10bit Rec.709 via HDMI from my Canon XF-400.

When I'm going to connect my iPad via broadcast mode with wifi, I'm able to grab a good looking image.
BUT:
When I now connect any destination to the RX device via HDMI or SDI then I don't get any image out of it.
The strange thing is that on the RX device the display says "720.576 P50" which is wrong.
I think because of the wrong resolution the video signal is unreadable for the destination (checked with Blackmagic Video Assist, Blackmagic UltraStudio).

Any suggestions what could cuase this issue?

Thank you
Markus.

I have the same problem on Canon Legria HF G70. Video transmission only works if I set the hdmi output to 720p 50fps or 1080i 50fps mode. When I set 1080p 50fps I have no picture and the RX says no video or 720.576 P50. It's frustrating.
Is there a solution or should I return the product?
Thanks

YamauchiSVK Posted at 8-14 12:59
I have the same problem on Canon Legria HF G70. Video transmission only works if I set the hdmi output to 720p 50fps or 1080i 50fps mode. When I set 1080p 50fps I have no picture and the RX says no video or 720.576 P50. It's frustrating.
Is there a solution or should I return the product?
Thanks

Thx for your message! I'm in contact with DJI support and I think your words will help us to catch the problem. I'll let you know if there is something new about this.