Hello guys.
Yesterday, after flying for about 20 minutes, I turned off my Mavic Mini1 drone, when I turned it on again after a while, the remote control and the aircraft did not connect. I tried the aircraft for pairing mode, I held down the on/off button for 4 seconds and it beeped. But the lights do not light up sequentially. The aircraft does not connect to the remote control. This happened suddenly. There was no crash, no software upload. I wanted to downgrade the software version with Assistant 2, it did not work. I kindly ask for your support in this matter.

Before anything else try removing the memory card from the drone and see what happens.
If they connect you probably have a mis named or corrupt file on hte memory card.

Sean-bumble-bee Posted at 8-29 09:54
Before anything else try removing the memory card from the drone and see what happens.
If they connect you probably have a mis named or corrupt file on hte memory card.

Of course. There is no card. I also tried formatting the card, I also tried with another card. I tried many times with different cables, different computers. It didn't work.

That's a pity.

Hi there,

Thank You for reaching out. We are truly sorry for the inconvenience you are experiencing.

Please try the steps for linking as in this site Aircraft Linking Guide  you can use the DJI Mini SE guide on the linking process.

If issue persist please provide us the exact RC model you are trying to connect with your aircraft. Please send us a video recording of the problem. This will allow us to investigate further and provide you with the most accurate solution based on the specific issue you're encountering.

We are looking forward to your response for further assistance. Thank You

DJI Gamora Posted at 8-30 22:51
Hi there,

Thank You for reaching out. We are truly sorry for the inconvenience you are experiencing.

Photos of my remote control and the aircraft are attached.

tween Posted at 9-2 09:49
Photos of my remote control and the aircraft are attached.

Hi there,

Thank You for getting back to us. Could you confirm if you have tried the linking process provided on the link above? Thank you for sharing the photos, please do provide us the linking process video for us to investigate further on this issue.

I hope this information has helped to clarify your inquiries. If you have any other questions, kindly let us know. Thank You!