c__e
lvl.1
Germany
Offline
|
Hi,
I have the Osmo Action 5 Pro and have the issue that after the camera is idle for a longer time (like hours, the next day or after charging), the _saving_ of the initial recording (no matter if it's video or photo) takes a very long time (like minutes).
It is expressed by the fact that the top left spinner besides the SD card symbol spins for minutes and the camera cannot be used until it is done (which is pretty annoying if you want to make a subsequent recording and your subject is gone until the camera saved the recording...).
This seems to be pretty independent from the duration of the recording - as said, it happens with either photos or videos - even if the video has only a few seconds duration.
Additionally, sometimes I noticed the recording of the first video is automatically aborted after something like 15 seconds and then the camera goes into the long saving - it feels like some buffer ran full and therefore it had to abort the recording.
It can also happen for the next few recordings after the initial recording but after a few recordings are made, the saving speed goes back to _regular_ speed (the spinner is only displayed for like 3 seconds).
And then it's all good until the camera is idle for a long time again...
Here is a video that shows saving a 5 second video recording after the camera being idle over night:
This happened with the original Firmware the camera was deliviered with as well as the newer firmware it is currently running on:
Firmware Version 01.01.05.20
Camera Firmware Version 10.00.10.18
Is this a known problem/did anyone else experience this?
|
|