DJI Question----- Well the X5 Vibration board work with the X3 Camera on the existing Inspire1? It would be nice to swap out both the cameras on the Inspire!
I put my order in for the adapter plate when first announced. It was listed as 10 week back-order at that time. I too will wait to get the X5 camera and eventually a whole new package to have 2. I'm kinda waiting for the software to stabilize and improve reliability before ordering another aircraft. It's time for DJI to focus more on service and reliability to their existing userbase before I order an $8k package.
ReppocMike Posted at 2017-12-26 04:49
Hi! I just install X5 VB to my old I1. I'm using X3. I can use my X3 with X5 VB, but mount lock can't turn lock position. What goes wrong?
you can take the gimbal lock off the old X3 VB and switch it onto the X5 VB. the gimbal locks and two cables are the same between the X3 and X5.
or i believe there is a screw that tightens and loosens the Lock, not sure though as i did the above when i got my X5 VB