TBMbrandon
lvl.2
United States
Offline
|
I've noticed with both GH4 and 5D gimbals that once a lightbridge unit is connected the shutter control function of ground station can not be executed.
I have nothing mapped to F2 on the A2 and have had successful missions without lightbridge connected so I know my servo position values are correct.
I've tested different configurations to see if I could gain control of the servo action and only when disconnecting the G7 connector from the GCU,
Which sends control inputs from the LB Air Unit, was I able to control the shutter.
This may be a matter that has already been discussed, but I haven't found much info when searching other threads.
Has anyone gone through a similar experience or am I just overlooking something simple?
Any feedback would be greatly appreciated!
Thanks!
|
|