chris_t
 lvl.4
Germany
Offline
|
Hi vasilis.
Within the Assistant Software you only can set "Go Home and Landing" as the First Level Protection to avoid low voltages. You just have to enter the enter voltage. Once this value is reached, your aircraft will return to the home point and then land.
I would not advise to do so. The aircraft will return from its current position to the home point in a straight line and therefore may fly into obstacles on this route.
Within the Ground Station Software you can click on "Go Home" (top right) after a mission is finished. The aircraft will then return to the home point on a straight route from its current position (again: danger of flying into obstacles) at 8 m/s (that's max speed for Wookong M, so no reserves left). It will then hover above the home point before it will land.
I had a major crash once when I tried it. The way back home was fine (although with 8 m/s too fast for my liking), but when it was about to land, it came down much to fast (with 6 - 8 m/s vertical speed) and hit the asphalt. We spend weeks trying to find out, what was the reason, but there was nothing odd to find. So, I would not advise this either.
Best is, to fly home and land by hand.
Regards
Chris |
|