Hi guys,           i recently bought a phantom and have been flying around for a while . few days back i tried to start the drone but when i push both the
sticks down and inwards i get rapid flashing red light the drone has gone through normal startup sequence with 4 green - 2yellow -3red (<5 GPS)

in phantom mode when i ARM the motors i get rapid red lights
in NAZA M mode i get 5 red lights

the battery is fully charged and done all the calibration

the assistant software does not show any error

i get a good GPS lock - verified with the help of 2.4GHz telemetry link.

so is there any problem with my flight controller? and what does the 5 blinking red lights during arming mean?
is there a solution to this problem?

thanks.  

are you in a no flyzone ?

Welcome to DJI products

umpa Posted at 2014-12-18 04:00
are you in a no flyzone ?

my naza m v2 works fine with gps and waypoint mode

rookie121 Posted at 2014-12-18 10:47
my naza m v2 works fine with gps and waypoint mode

Normally this issue may be the result of:
1. No GPS link to flight controller ( which you have excluded);
2. IMU calibration (please check whether the mod value is between the normal range in your software);
3. Drone is in flight restricted area (if so, your APP ground station interface will appear a circle on your map).
Looking forward to your reply

The Imu and compass mod values are well within the spec range and there is no no - flyzone red circle around tthe phantom
so is this error correctable ?

rookie121 Posted at 2014-12-22 15:50
The Imu and compass mod values are well within the spec range and there is no no - flyzone red circl ...

Hi, sorry for the late reply.
you could contact you dealer for further reparation.