Hi
In my new DJI Flip - IMU calibration stuck at 95% (2/5) for more than an hour now. I've keep connected the power line directly to the flip. Please advice what to do or wait for how long?

Best regards

that dangerous, an hour
please turn it off and let it cool down

I dont have the Flip, but yeah, sometimes it hard to calibrate the IMU
the trick is to use a wall with a 90° angle and just lean the drone on the wall depending on which direction it needs
and don't charge while IMU calibration

Kikik Posted at 3-6 09:47
that dangerous, an hour
please turn it off and let it cold down

Thank you for your kind response.
Ok, now turned off & tomorrow will try as per your suggestion.
Best regards

dohs Posted at 3-6 09:53
Thank you for your kind response.
Ok, now turned off & tomorrow will try as per your suggestion.
Best regards

You're welcome
I'll wait for further news

Hi there, thank you for reaching out. We apologize for the inconvenience. Could you please confirm if any error codes have appeared? If the IMU calibration fails or cannot be completed, please follow the troubleshooting steps outlined below:

1. Please ensure that the aircraft is placed on a horizontal plane during calibration.

2. If the machine is on standby for a long period, power it off first and let it cool to room temperature for a moment. Then power it back on and retry the calibration.

3. Kindly ensure that the firmware has been updated successfully.

Alternatively, you may provide the calibration operation video for us to assist in judgment. We look forward to your response!

Hi,
Appreciating your great, kind supports !!  Finally able to do the calibration smoothly after factory reset + download /install updates.
Sorry, it was my fault - as during 1st update process - accidently I re-started the drone. I thought RC2 taken care & ignored unintentionally.

Thanks again :-)

Best regards      

dohs Posted at 3-13 10:52
Hi,
Appreciating your great, kind supports !!  Finally able to do the calibration smoothly after factory reset + download /install updates.
Sorry, it was my fault - as during 1st update process - accidently I re-started the drone. I thought RC2 taken care & ignored unintentionally.

You're very welcome! We're excited to assist you. Your satisfaction is our top priority, so please feel free to reach out with any further questions or requests. We're here to support you every step of the way. Wishing you a fantastic rest of your day.