samlink93
New
United States
Offline
|
Ive had my Ronin M since June & it's worked fine (minus the obvious horizon tilt that would show up 2 minutes into every take) but over the last few days I've been having very mysterious issues with it.
Upon turning it on at my last shoot, the roll axis motor simply seems to be not working. The camera would tilt uncontrollably, and when putting it down to check it out the base of the roll piece was burning hot. I read to update the firmware, and upon my attempt to do so the Ronin immidietely got incredibly hot once again, & started smoking.
Powered off immidietely, very dissapointed in the quality of these DJI products lately. Are any of you aware of this type of issue? Please help, would be great to use on my shoot tomorrow!
|
|