Is there any chance DJI could (after the INAV full OSD has been supported) add a small, say 5 sec, delay between getting the disarmed signal from FC and actually stopping recording? This would allow INAV (and I believe Betaflight too) users to have the stats screen being recorded at the end of their flight.

Hi there, thank you for sharing your feedback and suggestions with us. We truly value your input and will ensure that it is promptly forwarded to the appropriate team for careful consideration. If you have any further questions or needs, please feel free to reach out. We are dedicated to providing you with the support you deserve. Wishing you a wonderful day ahead!

Yes, this is essential and I'm surprised that it has been overlooked.

This same thread has been started with same response before..   It's really annoying to always have my quadcopter flight recordings end about a half foot above the ground.  Not only does it stop recording the instant you disarm, it also means we often do not see the post flight summary in the DVR recording.   
DJI, this is an easy fix, so please fix it.      It doesn't drop to low power mode (and low frame rate) for a few seconds after disarm anyway, so there's no reason the recording can't keep going a little longer.

Daemon42 Posted at 3-15 18:53
This same thread has been started with same response before..   It's really annoying to always have my quadcopter flight recordings end about a half foot above the ground.  Not only does it stop recording the instant you disarm, it also means we often do not see the post flight summary in the DVR recording.   
DJI, this is an easy fix, so please fix it.      It doesn't drop to low power mode (and low frame rate) for a few seconds after disarm anyway, so there's no reason the recording can't keep going a little longer.

Hi there, thank you for reaching out and we do apologize for the inconvenience caused. Please know that all suggestions need to undergo evaluation and unfortunately, that takes time.  Also,  all customers can provide their suggestions and we will be more than happy to forward them to our relevant team but not everything will be approved as there may be some limitations such as technical or firmware limitations. Thank you for your understanding. Have a nice day ahead.

Daemon42 Posted at 3-15 18:53
This same thread has been started with same response before..   It's really annoying to always have my quadcopter flight recordings end about a half foot above the ground.  Not only does it stop recording the instant you disarm, it also means we often do not see the post flight summary in the DVR recording.   
DJI, this is an easy fix, so please fix it.      It doesn't drop to low power mode (and low frame rate) for a few seconds after disarm anyway, so there's no reason the recording can't keep going a little longer.

Well, it took them a few years to finally fix OSD issues so I'd say around 2030 we will have the disarm delay introduced to DJI Goggles 10