hi guys ... iv been running 1.1.9 FW from new as i like it and it gives me no problems .. i dont know what my RC FW is cause it doesnt tell me on the old pilot app i run ..

so the other day i installed the HDMI board and upgraded to DJI GO app .. the board was bought before i got my Phantom so it was one of the first ones made ..

the HDMI board has made my RC FW 1.1.9 so thats all of my set up is the same FW .. it tells me what my RC FW is on the new app ..

everything seems to be working perfect on the bench and iv checked my IMU and it says its good to go .. is there anything else i should do before taking it out and flying it ?

cheers guys ....

I would calibrate the imu regardless put it in the fridge for ten mins then calibrate it on a completely level surface and first time taking out do a compass cal as well.

Rocket_Aus Posted at 2015-11-6 22:17
I would calibrate the imu regardless put it in the fridge for ten mins then calibrate it on a comple ...

cheers I will do that ....