Gerry1124
Captain
United States
Offline
|
Open your "DJI Phantom 2 Vision Assistant_3.6" and connect your Phantom. Select the "basic" tab and the "rc" tab You will see "upgrade version and basic version. Select upgrade version. Then there will be 2 calibration sections that says start. Select START on the "command stick calibration" Have the rest of your system turned on also because you will need to move the tx sticks. Move both the tx sticks AND the control wheel at the top left to calibrate your camera. You do NOT need to select start under the "sticks monitor" forget that one. After that is done. you can go through the whole system and everything will work properly. Take your props off, start your phantom on the table, go through the motions and you will hear the motors speed up, slow down and see the camera move slow if you put a little movement on the wheel, or move fast if you put a lot of movement on the wheel. |
|