Just upgraded the Ronin M firmware and when I turn on the Ronin now, it starts auto-tuning stability (loud noise expected) but doesnt stop. The vertical axis motor heats up and I have to run off the Ronin to prevent further dmage.
Anyone else experience this?
1. Make sure the firmware are up to date, IMU1.4http://www.dji.com/product/ronin-m/info#downloads
2. Click on "Default" at the assistant software or APP to reset it back to factory default settings
3. Make sure it is well balanced before you turn on your Ronin-M
New
lvl.4
lvl.1