Screw that connects device holder to RC

Woffski · 2015-12-20

Just received a new device holder for my P3P RC from DJI. They replaced my old device holder with a new aluminum piece and I attempted to replace it but the old screw is too small for the new device holder. The new piece did not come with a screw. Does anyone know if there is somewhere to obtain the correct screw? Thanks.

Rebel · 2015-12-20

Tip: the author has been banned or deleted automatically shield

rskardon · 2015-12-20

It should have come with a screw, mine did and it was a different size

DJI-Patrick · 2015-12-21

Hi ,
Please contact US support center about that . Could you please post a picture of that ? We haven't changed the RC and the screws . The srews should be the same even in GL300A and GL300B .

Woffski · 2015-12-26

DJI-Patrick Posted at 2015-12-21 04:55
Hi ,
Please contact US support center about that . Could you please post a picture of that ? We hav ...

Patrick, I'm talking about the arm that connects to the RC. There is a screw that connects to the RC, on the right side, to the hard plastic arm. DJI sent me a new aluminum arm, and the screw hole is a little bigger than the original hole, requiring a thicker screw.

Rebel Offline Rebel Banned + Add Friend Person Message United States Offline	Tip: the author has been banned or deleted automatically shield

	2015-12-20 Use props