Will these rotors work with the Phantom FC40?

E300 9450 Self-Tightening Rotor (Thrust Boosted)


Thanks
Mark

I think they will, but they will be more than the FC40 (with its low AUW) needs.
These props were designed to lift heavy laden Phantoms and Phantoms flying at higher altitudes,

on that note.....

always stick with the official DJI propellers as all the other will reduce the flight time as well as might cause the IMU to go wild.

Not to mention the motors might over heat.

SFOS900 Posted at 2014-10-6 07:42
on that note.....

always stick with the official DJI propellers as all the other will reduce the fl ...

9450s are genuine DJI props

I have used the 9443 props and was so happy with their performance, I then installed the E300 9450 Self-Tightening Rotor (Thrust Boosted), genuine DJI props.

They are great for flying at 6,000' msl.  The air here is much less dense than at sea level.

Ill stick with my 8045s as I have three new sets just sitting here.  If/when I get down to my last set I'll try the 9450s.
Im really happy with the FC40s performance as it is.
Id nvr try the knock offs as Ive read too many problems with thwem, Ill stick with the OEM stuff, and I did find a local dealer so its easy for me to get parts now