I've had my P2V+ since September and flew it fairly often, but parked it until today.  My FPV/camera feed no longer works.  I can control everything else just fine, camera controls work, it will take stills an video but I cannot see what the camera sees.  

I've tried:

Re-binding the camera
Resetting all settings
Verified all firmware is up to date
Uninstalled/reinstalled the DJI app
Reset my phone (iPhone 6+)
A different SD card

None of this worked.  All other telemetry data does feed to the app.  The only thing not working is the video feed.  Really frustrating, because of course tomorrow I volunteered to do a roof inspection for a friend.  I can't do that without seeing what the camera sees in order to record the rooftop.

Any ideas?

Check this

http://www.phantompilots.com/thr ... .62334/#post-611917

My is send for warranty service.
i Ping ping 192.168.1.10 and no answer :-/

Try all of these!

http://forum.dji.com/thread-2528-1-1.html

Bah. Can't ping 192.168.1.10. X.X.X.1 and X.X.X.2 ping fine, but .10 doesn't show up. I got this used. How do I go about fixing this?

Trying dropping FPV resolutions to 240@15fps.
Else, its dead wifi module.

I already tried the lowest resolution and FPS settings. No luck.

I've searched for replacement modules. Cheapest out there seems to be $189. Is that realistic?

Double check the cables are fully seated in the base of the camera, it could be that simple but maybe not....not sure about the price of the modules, good luck!

The module has two pub board in it. One for video and the other is the telementry data. With all you've tried sounds like the video portion is toast. Check eBay you may find it cheaper there.

seems like the aircraft needs to be sent in, please contact DJI support about the RMA issue