I purchased a new RC with the gimbal control wheel on the upper left for my P2V+ (Ver. 2), hooked it all up and when the Vision software is on the software controls the gimbal up and down movements, but the wheel does nothing when the Vision software is turned on.

If the Vision software is off, the RC's gimbal control wheel will move the gimbal but it doesn't seem to lock in and wants to self-center to about 45 degrees on the vertical axis.

Can I get the RC's gimbal wheel to work when the Vision software is on?  Otherwise it seems like a waste of time.

Thanks, Eric.

Does anybody have or use the remote with the gimbal control wheel?

eric@desbuilder Posted at 2015-1-2 04:04
Does anybody have or use the remote with the gimbal control wheel?

I do. it works fine, but my V+  is a version 3.0 I did have to recalibrate it after doing all the firmware updates etc.

Eric

Try this.  Gil put this out.

Does the standalone calibration provide anything different than using the RC software?

I'm not sure that when I calibrated the RC using the software that I moved the gimbal wheel thru its range of movement. Could this be the problem?

eric@desbuilder Posted at 2015-1-2 07:43
Does the standalone calibration provide anything different than using the RC software?

I'm not sure ...

Yes. Definitely.

don't forget select 'upgrade version' in Transmitter version