Hello, I'm not completely new to DJI, started with a Phantom and now got 3 Inspire 1 here with 4 controllers. Unfortunatley now I've got some problems and need some help.

The DJI GO App works pretty fine on the first Inspire with a Samsung Galaxy Tab 4 SM-T230, Android 4.4.2, stock without some strange apps, USB Debugging ON, absolutely no problems at all.

Then there is the second and the same on the third Inspire 1, with permanent reconnects of the USB. Same type of tablet, same firmware.

Typical workflow:

start controller

start Inspire

start tablet

connect USB

answer the question to start DJI GO with yes

DJI GO starts and I’m able to connect to thecontroller/Inspire for a splitsecond then USB asks again to connect to this device. And shows up in themessages as USB device connected – again.

Are there any recommendations or known workarounds? I've tried to reboot and reinstall the whole tablet and app. No differences.

Best regards!

GS

You have tried to swap the usb cable?

Thanks for your reply,

Yes, the 2 short original DJI cables, fresh out of package and the original Samsung from the tab.