chowdah
New
United States
Offline
|
I was getting the "This App has been blocked for your protection" error when trying to install the drivers on Windows 10. I tried disabling driver signature verification, shutting off virus protection, launching the installer as an admin, and all kinds of other stuff. The only way that worked was booting into safe mode and installing the driver. In safe mode Windows didn't see the drone or the RC when plugged into the usb port, but I installed anyhow, thinking the usb channel I was using was disabled in safe mode. When I logged into the computer out of safe mode, the Vision Assistant 3.8 Software linked to the drone. Using that software I calibrated the RC through the drone. Couldn't get DJI RC Assistant version 1.2 to work with a direct connection to the RC unit with USB, but I can still charge the unit that way. I'm using an older software for an older drone, but the driver signature problem is the same for any other unsigned DJI drivers, so this may work for all of their older unsigned drivers. |
|