smurfscent
lvl.1
United States
Offline
|
Purchased the Phantom 3 Professional last night, upgraded the RC firmware with no problem. Downloaded Firmware v1.6.0040, read the PDF, watched the tutorial video, followed the steps.
The first time, it ran a few minutes, then the tone changed and the gimbal LED went from green/red to red and nothing but noise. I turned it off, waiting a minute, then turned it back on.
It blinks green/red as it boots. but wastes no time now to go directly to red and noise. The result.txt is as follows:
========== 2014.01.01 00:00:12 remo-con disconnect======
Packet: P3X_FW_V01.06.0040.bin
Upgrading ...
Result: Failed.
Reboot the aircraft and try to upgrade the firmware again.
========== 2014.01.01 00:00:12 remo-con disconnect======
Packet: P3X_FW_V01.06.0040.bin
Result: Failed.
Reboot the aircraft and try to upgrade the firmware again.
========== 2016.02.05 19:41:23 =====================
Packet: P3X_FW_V01.06.0040.bin
Result: Failed.
Reboot the aircraft and try to upgrade the firmware again.
========== 2016.02.05 19:50:13 =====================
Packet: P3X_FW_V01.06.0040.bin
Result: Failed.
Reboot the aircraft and try to upgrade the firmware again.
========== 2014.01.01 00:00:12 remo-con disconnect======
Packet: P3X_FW_V01.06.0040.bin
Result: Failed.
Reboot the aircraft and try to upgrade the firmware again.
========== 2014.01.01 00:00:12 remo-con disconnect======
Packet: P3X_FW_V01.03.0020.bin
Result: Failed.
Reboot the aircraft and try to upgrade the firmware again.
========== 2014.01.01 00:00:12 remo-con disconnect======
Packet: P3X_FW_V01.06.0040.bin
Result: Failed.
Reboot the aircraft and try to upgrade the firmware again.
Help!
|
|