David
lvl.3
United States
Offline
|
Well, after much confusion and the inability to update the firmware on my Phantom 3 Advanced or the remote controller, I decided to return it for a replacement to Amazon.com.
When I got the new one I also bought a new microchip to replace the factory one.
The chip is ... Lexar High-Performance MicroSDHC 633x 32GB UHS-I w/USB 3.0 Reader Flash Memory Card.
So, got the replacement, downloaded the new firmware to the drone, and started to update. I was having all kinds of "FAILED - REBOOT and TRY AGAIN" trying to update.
The controller wouldn't see anything so I switched to the controller from my first shipment and paired it to the aircraft. That worked seamlessly.
Then I started the update and LO AND BEHOLD, within a few minutes, it alerted it was done.
I checked the update with the "About" page in DJI GO app and found this... APP - V. 2.6.0 ---- REMOTE CONT. - 1.5.70 ---- AIRCRAFT - 1.6.40.
WOW !!!!! IT FINALLY WORKED AND IT WAS WORTH ALL THE HAIR PULLING.
|
|