Please select Into the mobile phone version | Continue to access the computer ver.
Slave control as dynamic home point
819 4 2015-1-5
Uploading and Loding Picture ...(0/1)
o(^-^)o
craigarthurson
lvl.2

Nigeria
Offline

Firstly please don't beat me if this has already been posted as can't find it.
All righty then can anyone answer this or know with the dual control system set up and operating can the GPS in the slave control be set as the dynamic home point as this could have the potential for for some great uses as to take of with the master in one location and finish with the Slave as the home point so during an arial operation the camera operator is the finishing location of what you are doing.
Does anyone know?
2015-1-5
Use props
abe
Second Officer
Flight distance : 524032 ft
  • >>>
United States
Offline

Not sure of the specific answer to your question, but note that the maximum distance between the master and slave controllers is 50 meters.
2015-1-5
Use props
rbendjebar
First Officer
Flight distance : 1792162 ft
  • >>>
United States
Offline

The only communication between pilot and craft is through the 2.4 GHz link of the Master RC. The camera op, working Slave RC, does not have a link directly to craft, but uses 5.8 GHz link to Master RC to send signal to camera/gimbal. So no, Slave cannot determine dynamic homepoint, only Master.
2015-1-5
Use props
DJI-Autumn
First Officer

China
Offline

Have tested it and yes slave controller can determine dynamic homepoint~
But just like @abe said the maximum distance between the master and slave controllers is 50m.
2015-1-6
Use props
craigarthurson
lvl.2

Nigeria
Offline

Thank you for that food for thought 5.8 Ghz range extender and relay might be worth toying with when mine finally arrives
2015-1-6
Use props
Advanced
You need to log in before you can reply Login | Register now

Credit Rules