Artiks
lvl.2
Flight distance : 979964 ft
Portugal
Offline
|
Hey guys!
As all of you know, the tablet/phone holder is attached to the transmitter with a screw. During the unpacking/packing of the drone everytime we use it, the screw gets loose and you can't adjust the device angle accordingly to your needs so you need to tighten again to make that happen.
The problem is that the screw is made with some sort of (plastic?) and its head gets scratched we can't tighten anymore. Do you guys think if we change for a aluminum/metal screw is a problem because of the antennas/signal? They are a lot more consistent...
I don't think that a screw is a problem for the antennas since the iPad itself has a lot of components that could cause more harm
Any of you have experienced our issue? How do you proceed?
Cheers
|
|