acoo0246
lvl.1
Flight distance : 271440 ft
Australia
Offline
|
Hi all,
Having trouble getting my zenmuse Z15-BMPCC to work. On power up, it appears to initiatlize ok, finds level and pointing foward but then starts a slow pan/roll to the right and down. Motors make a loud humming noise. The gimbal does not accept tilt inputs from the Lightbridge 2 ground unit even though the input is mapped and appearing to work in the Go app.
I cannot connect to the zenmuse assistant to perform an upgrade of the firmware - the blue and green lights on the assistant software seem to indicate there is a connection, however when I run Tools - > Upgrade I get the error telling me that there is a read timeout (presumably from the gimbal).
I have already replaced the GCU (after getting no help from the supplier - another story) - and this is problem still occuring, which leads me to believe that it might be the gimbal itself.
Has anyone else had the same/similar issues?
I have the following setup:
S1000 + A2 + Lightbridge 2 + Z15-BMPCC
|
|